Recovering data from a wet mobile is possible and is done on many occasions, but it requires a series of steps. Mobile accidents are very common.
The most common examples are a broken screen, splashes, or even phones falling into the water. But how can you recover data from a wet mobile? Keep reading! We tell you step by step what you should do. Do not miss it!
Read Also: How to Backup iPhone with Broken Screen? Easy Ways
Professional Treatment to Recover Data from a Wet Mobile
If your mobile has gotten wet, it is best to take it directly into the hands of professionals. There are many legends about putting it on rice or drying it with the dryer, but they are not more than that, legends.
Sometimes they may seem like they work, but problems will eventually emerge. If you want your mobile to have the option of a second life, go as quickly as possible to a technical service where these types of breakdowns are dealt with. It will be a laborious process and will require specific instruments, but the results will be very positive.
Disassemble the parts
First, you have to disassemble the parts to access the main components. Ideally, treat as many parts as possible individually. The motherboard is the most important part because it makes our mobile phone work.
Chemical Cleaning for Recover Data from a Wet Mobile
Second, you have to perform a chemical cleaning of the motherboard. This treatment eliminates the oxidation that may exist in any component. It is done with the help of an ultrasonic cleaner and with a liquid called isopropanol.
The liquid has to be poured into the cleaner very carefully, as isopropanol is highly flammable. When it has been poured, you have to take the motherboard and submerge it. Once inside, we will activate the cleaner at 30 W, approximately, and let it act for 10 minutes. In this first cleaning, we should be able to remove already a part of the corrosion that has been generated.
At the end of this first part, the power is increased to 50 W and the piece is kept for another 20 minutes inside the ultrasonic cleaner. In this way, we will be able to completely eliminate all corrosion.
It is necessary to do a chemical cleaning of the parts that may have suffered corrosion. The goal is to remove any trace of all the pieces. Therefore, it may take us some time.
Manual Cleaning for Recover Data from a Wet Mobile
Once the cleaning process with isopropanol is finished, we have to carry out a manual cleaning . To do this, it is advisable to use a soft brush and clean each component until there is no trace of dirt.
Dry the Pieces
The next step is to dry all the pieces. This procedure also requires special equipment that can remove all traces of water without damaging the components. In fact, you should never use an electric hair dryer.
To dry the mobile parts well, you must use a heating plate. The pieces are placed on it and left for approximately two minutes, at a temperature between 75 and 85 degrees.
Mobile Mounting
When the parts have finished drying, it is time to reassemble the mobile phone. It will be then when we can turn it on to check that it works correctly. It will be possible for us to recover all the information that we have inside. Keep in mind that not all phones can be repaired once they have gotten wet.
Trust Professionals to Fix your Mobile
As you can see, recovering data from a wet mobile is a complicated task that requires time and more than usual knowledge. You can try these methods at home if you have had an accident. However, you should think about it because if you make a mistake, the phone could suffer a worse breakdown.
It is necessary to avoid, above all, damaging elements such as the motherboard. If that happens, recovery is likely to be very difficult. In these situations, it is advisable to have the help of some professionals, because they can take care of solving them without error. They have the necessary equipment and, in addition, they have a lot of experience.